By the ElonMek technical team · Application Guide · Published 2026-09-25

Foam control is a system, not a product. The defoamer does its part, but how well the process around it lines up is what decides the outcome.
Process Designs That Feed the Foam
Long drops in the transfer line
The taller the vertical drop and the faster the flow, the more air the transfer pulls into the liquid, and it comes in as fine bubbles. Those micro-bubbles barely collapse on their own, so they keep building up.
The wrong agitator impeller
Get the impeller type, mounting height or speed wrong and the surface starts to vortex, pulling air in. Under high shear the large bubbles are chopped into micro-bubbles that are very hard to break, and holding the foam down gets a lot heavier.
Temperature outside the working range
Run too hot and the system viscosity falls. Some reactions start giving off gas, and the defoamer itself can break down or come out of emulsion.
Run too cold and viscosity climbs instead. The defoamer diffuses more slowly and the foam stops collapsing as quickly as it should.
Too much surfactant
Wetting agents, dispersants and emulsifiers are necessary in a great many formulations. Dose them too heavily and the same molecules that help the product turn into efficient foam makers and stabilizers.
Where to Optimize Process and Operation
Rework the agitation
Pick an impeller that pulls little air in. Set the mounting height so the blade does not sit above the liquid level and suck air into a vortex. Run the agitation in stages, slow while you feed and wet out the material, faster once you need to homogenize and disperse. Baffles inside the vessel break up the flow, and where the vessel allows it, feed bottom and off-centre rather than straight down.
Temperature and pressure
Confirm the temperature window the defoamer can work in, then hold the system inside that range. A controlled drop in pressure helps bubbles release and collapse, which counts most on closed reaction systems. Where the temperature swings widely, run a small gradient test first.
Change the order and timing of addition
Charge the base solvent and the matrix material first, then bring the surfactants in step by step. Add the defoamer before foam appears, topping up in small amounts through the peak foaming period instead of one large charge. Keep the defoamer away from concentrated surfactants before either reaches the bulk of the batch.
Equipment design
Take out the vertical drops and elbows the line does not need. Feed at several points rather than one hard jet at a single spot. If the layout allows it, feed below the surface.
