Landfill leachate, industrial wastewater and flue-gas desulphurisation all throw heavy, persistent foam. In FGD that foam can overload the demister and take the absorber down with it.

Fast break and long inhibition, and in membrane and UF/NF systems a product that does not foul the membrane or cut water yield.
A polyether built specifically for foam in power plant flue-gas desulphurisation. Non-toxic, leaves no spots, holds its chemistry in service and does not disturb the culture.
View specifications Mineral Oil / PE EsterA broad-spectrum polyether fatty-acid-ester defoamer that breaks or suppresses foam in aqueous systems. It is at its best in water-soluble polymer formulations and medium-to-high viscosity systems.
View specifications Mineral Oil / PE EsterA waterborne defoamer made by esterifying polyether with a fatty acid. It has broad compatibility, keeps foam down for a long time and leaves film formation and surface quality untouched.
View specifications Mineral Oil / PE EsterA waterborne defoamer built from polyether ester, a dispersing solvent and hydrophobic silica. It leaves no surface defects and does not interfere with film formation.
View specifications Mineral Oil / PE EsterA high-fatty-acid-ester emulsion defoamer for systems where ordinary silicone is the wrong choice. It leaves no oil ring and does not block membranes, and it breaks foam fast.
View specificationsA multifunctional polyether for processes that rule out silicone. It handles foam without leaving spots, picks
PolyetherA non-toxic polyether concentrate. It controls foam without leaving spots and picks up little moisture, and it
PolyetherA silicone-free, high-carbon polyether ester built for concrete admixtures, above all polycarboxylate water re
PolyetherA multifunctional polyether aimed at industrial cleaning. It clears the silicone-spot residue that silicone de
PolyetherAn end-capped block copolymer of propylene oxide and ethylene oxide built on a propylene glycol starter, molec
PolyetherA strong polyether made by catalysed block polymerisation of propylene oxide and ethylene oxide. Non-toxic, le
PolyetherA polyether made from propylene glycol or glycerol with propylene oxide and ethylene oxide. Compound it with a
PolyetherA non-toxic polyether that leaves no spots and picks up little moisture. It stays chemically stable in service
The same grade families are supplied to plants in Vietnam, Cambodia and Laos. The market pages set out the foam problems typical of those industries, country by country.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.