Factory-direct manufacturer · Tianjin, China · 6 defoamer types, 64 categories, 114 models

Adhesives & Polymerisation Defoamers

Emulsion polymerisation and high-solids adhesive systems trap foam during mixing and reaction. It shows up as viscosity drift and unstable particle size, and in coating applications as surface defects.

Adhesive laminating line applying polymer resin

What the defoamer has to do here

It has to work at high solids and high viscosity, give real degassing performance, and not create surface defects or weaken film formation.

Recommended

Models Usually Specified for Adhesives & Polymerisation

Also consider

Other Models in the Same Chemistry

Before you specify

Adhesives & Polymerisation: questions we get asked

Will the defoamer create surface defects in the adhesive film?
That is the risk we design against. At high solids and high viscosity a badly chosen defoamer leaves craters or weakens film formation. Start low, check the dried film, and step up only if foam persists.
Which model for emulsion polymerisation?
4416 / 2308 is the usual starting point for emulsion polymerisation and high-solids adhesive systems. Tell us the monomer system, the solids and the reactor temperature and we will narrow it.
Can the defoamer be added to the monomer feed?
That depends on the grade and on where your foam is generated. In many polymerisation processes the practical answer is to split the dose between the initial charge and the feed. Send us the process sequence and we will advise.
Markets

Buying from Southeast Asia?

The same grade families are supplied to plants in Vietnam, Cambodia and Laos. The market pages set out the foam problems typical of those industries, country by country.

Send us your foam system

Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.