Laos’s industrial load is dominated by mining, hydropower and rubber. Foam is a different problem in each: in flotation it is a control variable, in water treatment it is an operating limit, and in latex it is a quality defect.

Frothers are added on purpose in flotation, so a defoamer here is not a foam killer but a balance: too much and the froth collapses and recovery falls, too little and the froth overflows the cells and floods the launder. Thickener overflow and tailings lines foam for a different reason — residual reagents and fine solids.
Reservoir and process water carried through screens, clarifiers and aeration basins can foam where organics concentrate. On a hydropower site the practical consequence is fouled screens and nuisance foam below the outfall, not a process failure — which is why the dose has to be modest and predictable.
Latex and skim rubber foam during straining, blending and ammoniation. Air trapped in the block becomes a density and appearance defect, and silicone residue becomes a cure problem.
Smaller plants — sugar, beverage, sauce and fish processing — meet foam in mixing and filling. Low dose and a residue profile the QA team accepts matter more here than raw knockout power.
Photographed at the Tianjin plant: batch labelling, the QC bench that releases a batch, and the packing a liquid grade travels in.



| Model | Chemistry | Typical use | Property data |
|---|---|---|---|
| 30801 | High-content silicone-polyether emulsion | Thickener overflow, tailings and general plant foam | Data |
| 2030L / 121L | Silicone-free polyether | Aeration basins, clarifiers and water loops | Data |
| 2030 / 2080 | Polyether | High-temperature and alkaline water systems | Data |
| 530-4 | Mineral oil | Slurries, fillers and plant-wide foam control | Data |
| 663 / 65340 | Silicone-free fatty alcohol ether | Latex, rubber and silicone-sensitive systems | Data |
Typical uses are indicative and describe where the grade is normally applied, not a guaranteed fit. Every property table is published on the product page.
We have provided technical support to industrial buyers in Southeast Asia, Laos included. Reviews are done in English over email or WhatsApp: what the foam looks like, where it forms, what the water chemistry is, what has already been tried.
Every grade is produced at our own plant, in production since 2009, and each model carries a published property table so a metallurgist or plant chemist can compare active content, viscosity and ionic type before requesting anything.
Samples are small and meant for a trial inside your own circuit. Tell us the system and we will name the grades worth testing, plus the checks that decide between them — froth depth, recovery, COD, or cure.
Send the system: base chemistry, temperature, surfactant load and how the foam behaves. We will reply with the grades worth testing and how to read the result.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.