By the ElonMek technical team · Troubleshooting · Published 2026-10-05

In coatings production, foam and surface defects pull in opposite directions. Overdose the defoamer and you get orange skin and craters. Underdose it and the air stays in the film.
One coatings plant had been fighting this for years.
Severe Orange Skin That Simple Adjustments Would Not Fix
The plant makes water-borne architectural coatings. With a third-party defoamer in the formula, orange skin showed up after roller coating.
The technical team at the supplier gave the obvious answer — cut the defoamer dose. Nobody looked at the rest of the formula. The problem never fully went away.
With production stability on the line, the plant came to us for a foam-control package that was both stable and affordable.
After a first look at the water-borne architectural-coating system, we suggested a mineral-oil-based defoamer. It is a well-established choice for water-based coatings: it wets the substrate well, carries little risk of cratering or orange skin, and the cost stays predictable.
Troubleshooting the Additive Balance
Even with our defoamer in the tank, the orange skin was still there. Management blamed the dose — an assumption carried over from earlier suppliers, where every surface problem was put down to too much defoamer.
We did not take that at face value. Our consultants went through the actual feeding procedure and the existing formula ratios line by line.
Working through the formula together, we found the real cause. It was not the defoamer at all. The wetting agent was underdosed.
A defoamer works by dropping surface tension to kill foam. A wetting agent supplies the spreading power. In a formula they have to pull together and stay in balance. On that basis we left the defoamer dose exactly where it was and raised the wetting agent by 0.2 ‰ (two parts per thousand). The orange skin went away.
What the Case Shows About Additive Interaction
It looks like a simple film defect, but it points to something a lot of coatings producers — and more than a few defoamer suppliers — get wrong. You cannot pin a surface defect on one additive. Usually it is the whole formula, the way the additives interact and the production conditions working together.
We have spent over 30 years developing and making defoamers, and we offer more than 300 grades for different operating conditions. Industry research and time on plant floors go into the technical support we give. When something goes wrong on your line, our team works back to the root cause inside the system and hands you a fix you can act on, as part of a full foam-control solution.
