A strong polyether made by catalysed block polymerisation of propylene oxide and ethylene oxide. Non-toxic, leaves no spots, and it does not disturb the culture strains in the fermenter.
A powerful polyether made by catalysed block polymerisation of propylene oxide and ethylene oxide, started on propylene glycol or glycerol. It is non-toxic, controls foam without leaving spots, picks up little moisture and holds its chemistry in use. That puts it into most processes where silicone defoamers are ruled out. It also works as an emulsifier and as a component in emulsion polymerisation and detergent formulations.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | 3014 | SX3000 |
|---|---|---|
| Active content | ≥99.0 | ≥99.0 |
| pH | 5.0-7.0 | 5.0-7.0 |
| Ionic type | Non-ionic | Non-ionic |
Cloud point and temperature tolerance decide the choice: a polyether is only useful inside the temperature window where it stays compatible with the liquor. Active content then sets the dose, and ionic type sets whether it will sit quietly next to the surfactants already in the tank.
The models in this family differ in the properties tabulated above; those columns, rather than a product name, are what a shortlist has to be built on.
Polyether grades are chosen for temperature and for systems where a silicone would be incompatible. Trial at the temperature the process actually runs at, not at room temperature: a polyether that looks slow on the bench often performs once the liquor is hot, and the reverse happens as well. Keep the dose low and step it, because polyether over-dosing tends to show up as cloudiness or as foam that collapses and then rebuilds thicker.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
A multifunctional polyether for processes that rule out silicone. It handles foam without leaving spots, picks
A non-toxic polyether concentrate. It controls foam without leaving spots and picks up little moisture, and it
A silicone-free, high-carbon polyether ester built for concrete admixtures, above all polycarboxylate water re
A multifunctional polyether aimed at industrial cleaning. It clears the silicone-spot residue that silicone de
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.