Polycarboxylate superplasticisers are surface-active by design, so they foam during synthesis and again in the mixer. Entrained air costs compressive strength and leaves a surface that has to be reworked, which is why the admixture producer ends up buying a defoamer whether or not the mix design asked for one.

The esterification and polymerisation steps entrain air, and the reactor foams against the agitator. Foam carry-over wastes batch volume and can block the transfer line.
Admixture dosed into a mixer at high shear foams on contact. Air in the mix lowers strength and shows as a surface that has to be floated again.
Powder systems foam when the polymer redisperses. Powder grades have to disperse cleanly in the dry blend, which is a different trial from a liquid.
Photographed at the Tianjin plant: batch labelling, the QC bench that releases a batch, and the packing a liquid grade travels in.



| Model | Chemistry | Typical use | Property data |
|---|---|---|---|
| 1101-2 / 1817 | Polyether | Polycarboxylate water reducers, Ready-mixed concrete | Data |
| F681 / 2918N | Silicone & Ether | Polycarboxylate water reducers, Ready-mixed concrete | Data |
Typical uses are indicative and describe where the grade is normally applied, not a guaranteed fit. Every property table is published on the product page.
Our team has provided technical support to converters and formulators in Vietnam, Cambodia and Laos: reviewing the foam system, naming the grades worth testing and reading the trial results together. Everything runs in English, by email or WhatsApp.
Every grade is made at our own plant in Tianjin, in production since 2009, and each model carries its own property table on this site. A formulator can compare active content, viscosity, pH and ionic type before asking for a sample.
Tell us the system and the problem, and we will say which models to compare and how to run the comparison. Sample quantities are small on purpose: the aim is a decision on one grade, not stock on a shelf.
Send the system: base chemistry, temperature, surfactant load and how the foam behaves. We will reply with the grades worth testing and how to read the result.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.