A mineral-oil defoamer whose actives are a specialty polyether and silica. It breaks foam fast and holds inhibition for hours across water-based systems.
Mineral oil carries the actives, a specialty polyether and silica. The blend suits water-based adhesives, textile printing pastes and heavy-build coatings, where foam is stubborn and slow to collapse. It drops foam fast and holds it down through the run, and one grade covers all three lines.
Each model below represents a different internal structure. Select the model that matches your foaming system. Values are typical and indicative, not a specification.
| Property | 1308 | 1309 |
|---|---|---|
| Appearance | Yellow oily liquid | Yellow oily liquid |
| Viscosity (25 °C, mPa·s) | 100-1500 | 100-1500 |
| pH | 5.0-7.0 | 5.0-7.0 |
| Ionic type | Non-ionic | Non-ionic |
Carrier oil, active content and cost per kilo of active matter decide this range. The ester and polyether-ester grades are chosen where a straight mineral oil would affect the finished film or sheet; the mineral-oil grades are chosen where nothing downstream is sensitive to oil.
The models in this family differ in the properties tabulated above; those columns, rather than a product name, are what a shortlist has to be built on.
Mineral-oil, ester and polyether-ester grades are the economical route for aqueous systems that do not need silicone performance. They carry a carrier oil, so trial them on the same batch you will run commercially and check for any effect on the downstream film, print or sheet: oil-based grades can change drying or appearance where silicone grades would not. Read the ten-minute foam height and the appearance of the finished product together.
Supplied as a non-hazardous good. Liquid models are packed in 25, 50 and 200 kg plastic drums or 1000 kg IBC totes; powder models in 20 kg cartons. Shelf life is 12 months in a sealed container, stored indoors and away from direct sunlight. Mix or shake before use; if diluted before use, use the diluted product within the same shift.

Download TDS (PDF) Request MSDS
The technical data sheet restates the typical property table above for purchasing and QA files. A GHS safety data sheet is issued per model on request, because classification follows the exact grade and the destination regulation.
The 202 grade pairs polyether ester with mineral oil and hydrophobic silica; 7501 is the waterborne version, b
A broad-spectrum polyether fatty-acid-ester defoamer that breaks or suppresses foam in aqueous systems. It is
A mineral-oil defoamer built on mineral oil, vegetable oil, a fatty acid amide and a dispersant. It gives broa
The 4416 grade is mineral oil with hydrophobic silica and a dispersant; 2308 is mineral spirits with isoparaff
The same grades are quoted to converters and formulators in Vietnam, Cambodia and Laos; each market page covers the foam problems we are usually asked about there.
Base chemistry, temperature, shear and current dosage. Our technical team will run a shake-down trial and recommend a model and a dose, normally within 24 hours on working days.